水硬性石灰合成及拉破坏特性试验研究

水硬性石灰在欧洲石质文物修复和加固中获得了很大成功。我国的石质文物主要是砂岩,水硬性石灰的修复效果不好。为满足我国石质文物修复和加固的需求,本文以石灰石和黏土为原料,在950℃煅烧不同时间,制备出水硬性石,对试样的成分、微观形貌、收缩率、抗拉强度和拉破坏过程等进行了研究。结果表明:(1)试样中含有水硬性成分2CaO·SiO2(C2S);煅烧8h时,成分与欧洲水硬性石灰NHL5接近;1.5CaO·SiO2·xH2O(C-S-H)和CaCO3的含量随龄期的增加逐渐增加。(2)龄期1~3d,收缩率较小;龄期4~6d,收缩率以线性规律增加;7d以后,收缩率趋于稳定。(3)局部变形区随拉应力的增加而变大,邻近局部变形区逐渐合并,形成面积更大的应变局部化带;载荷超过峰值后,产生微裂隙;随载荷进一步增加,微裂隙扩展,贯穿整个试件,发展成宏观裂隙,使试件破坏。(4)抗拉强度随龄期的增加而增加,水硬性石灰中C-S-H、CaCO3等相互交织,构成空间致密体,使试件力学强度提高。合成的水硬性石灰物理力学性能与欧洲水硬性石灰NHL5相近,并且成分均匀、可控,在石质文物修复和加固工程中具有良好应用前景。     

基于近似解析法的超导储能磁体设计

降低超导储能磁体的研制成本一直是控制超导磁储能系统(Superconducting Magnetic Energy Storage, SMES) 总成本的重要手段之一. 本文考虑在一定磁体结构参数范围内, 磁体产生的最大磁场值可以采用级数进行 表示, 磁体的电感值可以采用线性函数表示, 给出了超导储能磁体磁场能量的近似解析表达式, 提出了一种基于近 似解析法的超导储能磁体设计方法. 该方法以储能磁体的线材用量最小作为设计目标, 在给定超导线材参数和临界电流特性曲线, 以及磁体储能总量要求的情况下, 依据此方法可快速的得到成本最优时所对应的磁体结构参数.将近似解析法优化和采用传统的有限元软件 Ansys 仿真优化进行对比分析, 结果表明采用近似解析法进行磁体优化更加方便快捷, 节省了大量计算时间.     

秦巴山区芋头中微量元素含量的测定

采用微波消解电感耦合等离子体原子发射光谱仪(ICP-AES)测定了秦巴山区芋头中5种微量元素的含量。结果表明,芋头中Fe、Se、Zn、Mn和Cu的含量分别为:321.40、158.77、47.45、5.24和4.09 mg·g-1;加标回收率为97.0%~106.5%,精密度实验RSD为0.59%~2.76%,测定结果具有良好的准确性和精密度。     

轴流压气机势流和尾迹相互干涉叠加效应分析

尾迹与势流的相互作用对压气机叶片表面的压力波动强度和出口的轴向速度分布及波动会产生很大影响。针对两级跨声速轴流压气机,采用数值方法研究两排转子叶片周向相对位置不同情况下,叶片表面压力波动抵消区域位置发生的变化。研究结果表明:转子叶片周向位置的变化会对静子叶片尾迹形态产生影响,会导致叶片表面压力波动抵消区域发生变化。伴随转子叶片周向相对位置的变化,存在上游转子叶片尾迹减缓下游静子叶片尾迹衰减的现象,从而改变了叶片排之间的相互干涉强度,并使叶片表面压力波动强度发生变化。     

膜流动电位测试中Ag-AgCl电极的制备及稳定性研究

膜的动电特性研究中,往往采用流动电位方法。该方法中,Ag-Ag Cl测试电极的质量是影响测试准确性的关键要素。本文采用正交试验设计和方差分析,着重考察电解法制备Ag-Ag Cl电极过程中,电流强度(I)、氯化时间(t)、电解质溶液浓度(CHCl)、电极来源(n)、烘烤温度(T)、活化电极溶液浓度(CKCl)等因素对Ag-Ag Cl电极稳定性的影响。得到Ag-Ag Cl电极的最优制备参数为:电流密度3.0m A/cm2,氯化时间50min,盐酸浓度0.1mol·L-1,烘烤温度120℃,活化电极溶液(KCl)浓度0.001mol·L-1;最显著影响因素为电极来源,显著影响因素为氯化时间和烘烤温度。对最优条件组合下制备的AgAg Cl电极,进行了稳定性实验,结果表明:制备的电极具有较好的稳定性,24h内电极电位漂移量小于0.10mv,7天内电极电位漂移量小于0.2mv;在聚偏氟乙烯中空纤维超滤膜流动电位测试中,流动电位与流动压差具有良好的线性和可重复性,回归曲线R20.99,变化规律符合Helmholtz-Smoluehowski公式,可以较好满足膜的流动电位测试要求。     

Synthesis and Characterization of a New Metal-organic Framework with Nou Topology

A new compound, [H2N(CH3)2]2[Zn(btec)].H2O(1, H4 btec = 1,2,4,5-benzenetetracarboxylic acid) has been solvothermally synthesized and structurally characterized by singlecrystal X-ray diffraction. The crystal structure is of monoclinic, space group P21/c with a = 9.5741(3), b = 14.5044(4), c = 13.7329(5) , β = 100.582(4)°, V = 1874.61(10) 3, C14H20N2O9 Zn, Mr = 425.7, Z = 4, Dc = 1.387 g/cm3, μ = 1.349 mm-1, F(000) = 776, R = 0.0560 and w R = 0.1684 for 2834 observed reflections(I 2σ(I)). Compound 1 based on μ4-btec and tetrahedral building unit features a three-dimensional(3D) anionic framework with mixed connected nou topology. The luminescent property and thermogravimetric analysis of compound 1 are investigated.     

EAST ������ICRF ���ߵ���ά��ų�����

The performance of the four strap ion cyclotron range of frequency (ICRF) antenna in EAST was studied by three dimensional electromagnetic code CST MWS. The coupling impedance with various frequencies, the distribution of current on straps and the power spectra for the three types of phases were calculated. The voltage breakdown and ICRF-related impurity were also studied. Simulation results show that the coupling impedance and power spectrum of the antenna design were reasonable, however, highest electric field, which is 3.61MV•m⁻¹ for (0, 0, 0, 0) toroidal phasing at the local area, exceeds the empirical value of breakdown. After the structure size was optimized, the maximum of E-field was below the breakdown value, the results also show that the high radio frequency (RF) potential was close to the antenna limiter, the RF potential along total B-field in front of Faraday screens 10mm for (0, π, π, 0) phasing was one-third of that for (0, 0, π, π) phasing.     

激光能量对反钙钛矿GaCMn_3薄膜结构与物性的影响

本文采用脉冲激光沉积方法在LaAlO3(001)单晶衬底上制备了反钙钛矿GaCMn3薄膜,通过控制制备过程中脉冲激光的能量,研究了不同激光能量条件对GaCMn3薄膜结构与物理性能的影响.分别利用X射线衍射仪、原子力显微镜、超导量子干涉仪和物理性能测试系统,对所制备的薄膜的晶体结构、表面形貌和磁性、电输运性质进行了研究.结果表明,制备的样品均为具有多个晶面取向的反钙钛矿薄膜,且薄膜结构和物性明显随制备激光能量的变化而变化.当激光能量为450mJ时,制备的薄膜多晶面取向性最弱,结晶性和表面形貌最优良.实验所得的薄膜均表现出顺磁-铁磁-反铁磁相转变,然而转变过程比块材较平缓,同时薄膜的电阻率并未表现出块材中的突变特征,我们推测该现象很可能是由衬底的应力及衬底的晶格膨胀对薄膜反常晶格变化的抑制作用造成的.     

Stochastic and upscaled analytical modeling of fines migration in porous media induced by low-salinity water injection

Fines migration induced by injection of low-salinity water(LSW) into porous media can lead to severe pore plugging and consequent permeability reduction. The deepbed filtration(DBF) theory is used to model the aforementioned phenomenon, which allows us to predict the effluent concentration history and the distribution profile of entrapped particles. However, the previous models fail to consider the movement of the waterflood front. In this study, we derive a stochastic model for fines migration during LSW flooding, in which the Rankine-Hugoniot condition is used to calculate the concentration of detached particles behind and ahead of the moving water front. A downscaling procedure is developed to determine the evolution of pore-size distribution from the exact solution of a large-scale equation system. To validate the proposed model,the obtained exact solutions are used to treat the laboratory data of LSW flooding in artificial soil-packed columns. The tuning results show that the proposed model yields a considerably higher value of the coefficient of determination, compared with the previous models, indicating that the new model can successfully capture the effect of the moving water front on fines migration and precisely match the effluent history of the detached particles.     

航空导管弯曲试验的疲劳裂纹萌生寿命

飞行器液压导管受接头和卡箍等约束，在使用的振动环境中，会因弯曲应力而导致破裂，影响到飞行安全．本文对飞行器液压系统通用的不锈钢导管的裂纹萌生寿命进行了试验研究．首先在对8 mm、12 mm 无缺陷导管和含U 型缺口8 mm 导管的疲劳试验和有限元分析的基础上，得到了导管的最大拉应变-裂纹萌生寿命数据．然后采用基于强度极限和弹性模量估算法的Manson-Coffin 公式来预测导管裂纹萌生寿命．最后引入加载类型修正系数、表面质量修正系数、试样尺寸修正系数、应力集中敏感系数和有效应力集中系数，使修正后的公式对三种类型的导管均有较好的裂纹萌生寿命预测精度．